9.10 Wireless sensor settings
An optional wireless measurement system for indoor conditions is available to Gebwell’s heat pumps. The system includes a Modbus base station and wireless sensors. The sensors can be used to read the temperature and relative humidity of a space. The controller’s software currently supports ten sensors.
You can enable the system in the service menu, under Commissioning / Wireless sensors.
The Modbus settings of the base station (address, parity and stop bit) can be found in the installation instructions that come with the system.
Nr. of wireless sensors: number of sensors (factory setting = 0)
Addr. wireless base station: address of the base station (factory setting = 1)
Baud rate (factory setting = 9600)
Parity (factory setting = None)
Stop bits (factory setting = One)
These settings will take effect when you restart the controller.